| |
The PP500 Series LED Lighting Controllers |
|
| |
- Compatible with nearly any LED lighting assembly available today
- Two independently controlled output channels
- Push button interface with optional Ethernet connectivity
- SafeSense® technology for safe overdriving
- Small compact unit with optional DIN mounting available
|
PP500 Range Quick Specification
- - 2 channel output
- - Optional Ethernet interface
- - 10A maximum pulsed
- - 2A maximum continuous
- - Supply voltage 12-48V DC
- - SafeSense® enabled
- - 20?S minimum pulse width
- - Optional 1?S pulse width (F version)
- For a full specification please refer to the refer to the datasheet
|
|
To get the very best out of your LED lighting solution, in terms of brightness stability and control, the lights should be driven from a current source, not a nominal voltage supply. The Gardasoft controllers are current sources. The PP420 LED lighting controller offers four output channels which are independently controlled.
|
| |
Each channel can be individually configured to output continuously; or pulsed based on an external trigger signal or internal timer.
|
| |
Software interface
Web browser interface
Click on the thumbnails to preview the screen images
|
The ‘F’ version controller will allow pulse width control down to 1µS resolution. Selected mode allows switching of the light based upon the state of an external trigger.
The PP520 models can be quickly configured using our free software which can be downloaded from this page, or even simply by accessing the controller via your internet browser; type in the IP address for the controller into your browser and you have full access to all of the parameters. Using a third party software package? Not a problem. The PP520 range has a simple command set that is detailed in the manual allowing easy communication.As with all Gardasoft
|
|
| |
products, all the settings are stored in non volatile memory, and it will retain these settings even when the Ethernet connection is disconnected.
Using our patented SafeSense® technology, the PP500 range allows you to overdrive your LED lights safe in the knowledge that the lights will be protected from damage. SafeSense® regulates the pulse width timing and duty cycle, depending on how high you are overdriving the light. The end result is you get the maximum light possible for your application.
When overdriving you may need to increase the DC power input to the controller or heatsink the controller due to power dissipation. If this is an issue for your application we would recommend the new RT200 series controller, which has all of the features of the PP500 series but is based around our SafePower® switch mode power supply design.
The full product specification is detailed on the product datasheets. Please click on the left hand buttons to access the datasheets, manual, software and application notes.
|
| |
|
|
|
